Peugeot 308 Key Fob Replacement
Peugeot's 308 is somewhat old-fashioned but it's attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can assist whether the issue is ongoing or intermittent.
peugeot 308 key fob replacement www.g28carkeys.co.uk
If you leave your key fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting, or canyoning, it's more likely to sustain water damage. The best way to prevent this from happening is to keep it in a dry bag whenever you're outdoors or performing activities that require the fob to be exposed to high levels of water.
It's also essential to make sure that the fob has dried before you open it up and then use it again. If you smell any odors from the fob (such as industrial liquid or windshield washer fluid), this is another indication that it's submerged.
A wet circuit could cause the battery's energy to drain or even explode. If you can get the 308 keyfob from the water and turn it upside up and shake as much water out as you can before opening the casing. Take the battery out, and then wipe the circuit board clean with a cotton swab, which has been dipped into 90-percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery, receiver module problems signal interference or a malfunctioning chip. If none of the above are the problem, you can reset the system by disconnecting 12 Volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from afar by warming up or cooling down the car prior to entering. This feature is extremely beneficial, especially during cold winter months. However, sometimes the remote start system ceases operating due to a range of causes, such as the battery of a coin that is dead.
The coin-shaped battery inside the key fob can last between two and four years based on how often it's used, the location it was purchased, and how it is used. The date of use is typically written on the package or marked in the manual.
If the key fob stopped functioning after being exposed to clean tapwater, take out the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing it. In the event of exposure to soapy or salty water, the chip may be damaged and you'll have to replace the key fob in total.
If you're not sure the battery is in good condition it is possible to test its voltage using an instrument set to the car's voltage range, and connect it to the minus and plus terminals. The voltage should be around 12 to 13 volts, but if it's lower, the battery must be replaced. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.
Faulty Receiver Module
If you aren't seeing the "Key Detected" you might find that your receiver module is malfunctioning. It's the component that sends an indication to the car when the key fob is activated that also acts as an immobiliser. It stops it from starting until the correct key is present.
This could be caused by many causes, such as water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, like the electronic chip located on the inside will be damaged. In this scenario, you'll need to take the unit apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. When the battery is clean, you can try again.
If the problem persists it is a good idea to visit a local Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the issue and then fix it.
Losing your Peugeot car keys could be an incredibly stressful experience. A qualified auto locksmith will be able to solve the issue in minutes. They can program your car and cut a brand new, functioning key for you. Find a locksmith near you.
Electronic chip that is malfunctioning
The electronic chip inside your Peugeot 308 key fob is a very important part of the remote control system. If the chip is damaged, you may encounter issues starting your car or get a message saying "anti-theft". In this situation, the only solution is to replace the key. Luckily, auto locksmiths who are professionals are able to provide this service in the shortest amount of time.
The chip in the chip of your Peugeot 308 key fob can fail due to water damage, sweat, dirt or other reasons. If your Peugeot key fob has been exposed to soapy or dirty water, it must be cleaned right away. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. After that, you should allow the battery to completely dry.
Sometimes keys may be inoperable due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. This could be due to poor conditions or objects in the vicinity of the vehicle. It is recommended to see a Peugeot dealer if you experience this problem.
The Peugeot 207/308 Key Fob is delicate and needs special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset your on-board computer by disconnecting the battery for a few minutes. Be sure to disconnect the negative first, and then the positive.